How to Clean a Fujifilm X100VI Camera

Step-by-step instructions

Step 1: Power down and prepare a clean area

Turn the X100VI off, disconnect USB-C and HDMI cables, remove the strap if it obstructs cleaning, and let the camera cool. Work over a clean table rather than outdoors where blowing dust can immediately return. Keep the lens cap on while cleaning the body. If the camera was splashed, Fujifilm says to remove liquid immediately with a dry cloth; do not power-test a wet camera.

Step 2: Blow away loose exterior dust

Point openings downward and use gentle squeezes from a hand blower across the body, control dials, hot shoe cover, viewfinder surround, seams, and lens barrel. Never use workshop compressed air, an air compressor, or canned air close to the camera; pressure and propellant can drive contamination inward. Do not rotate or force gritty controls until particles have been lifted away.

Step 3: Wipe the body dry

Fujifilm specifies a soft dry cloth after each use. Fold a clean cloth into small working faces and wipe the top plate, grip, base, controls, and exterior lens barrel without pressing liquid into gaps. The manufacturer warns against alcohol, thinner, and other volatile chemicals because they can deform or discolor the leather covering. Skip general disinfecting wipes, polish, and household glass cleaner.

Step 4: Clean the fixed lens front element

Remove the cap and use the blower first. If a fingerprint remains, place one small drop of optical lens fluid on lens tissue or a clean optical cloth—never directly on the glass. Wipe gently from the center outward with a fresh surface. Do not flood the edge, scrub coatings, clean while grit is present, or attempt to unscrew the fixed lens assembly.

Step 5: Clean the monitor and viewfinder windows

Fujifilm directs users to remove monitor dust with a blower and then wipe gently with a soft dry cloth. For a stubborn stain, use lens paper moistened with a very small amount of lens-cleaning fluid. Apply the same low-moisture principle to the external viewfinder windows and eye sensor. Avoid pressure on the tilting display and keep fluid out of its hinge.

Step 6: Check ports, hot shoe, and contacts

Keep connector covers closed during ordinary exterior cleaning. If the battery or memory card is removed, wipe dirty metal contacts only with a clean dry cloth, as Fujifilm's troubleshooting guidance suggests. Never put cleaner, swabs, or metal tools into the card slot, battery compartment, USB-C port, microphone opening, or hot shoe. Persistent contact corrosion needs qualified service.

Step 7: Handle apparent sensor dust correctly

The X100VI has a fixed lens, so do not search for a body cap or try to expose the sensor. Photograph an evenly lit plain surface to confirm repeat spots, then run D USER SETTING > SENSOR CLEANING as the manual directs. If fixed marks remain in the same image locations after built-in cleaning, contact Fujifilm service rather than dismantling the camera.

Step 8: Reassemble, inspect, and store

Let any trace of optical fluid evaporate, reinstall the lens cap, and check that all covers are seated. Make a test image and verify the viewfinder, monitor, focus, dials, and buttons. Store the X100VI dry with the battery handled according to the manual and silica gel maintained appropriately. Fungus, liquid ingress, haze inside the lens, sticky controls, or impact damage calls for service, not stronger cleaner.