Kitchen & Appliances

How to Clean a Breville Juice Fountain Cold Plus

The Breville Juice Fountain Cold Plus BJE530 is easiest to clean before pulp dries in its mesh filter. Breville directs owners to switch off and unplug, dismantle the collector assembly, rinse parts promptly, and scrub the filter basket from both sides with the supplied brush. The basket contains sharp cutting blades, the motor base must never be immersed, and dishwasher permissions are not identical for every piece: Breville excludes the motor base and food pusher, places the filter basket on the top rack, and warns that routine dishwashing can shorten component life.

Published · Updated

Primary reference: Breville BJE530 Juice Fountain Cold Plus official instruction manual. Always check the manual for your exact model.

Quick reference

Before cleaning
Switch off, wait for a full stop, unplug, and dismantle by the manual.
Filter
Soak 10 minutes, brush inside and outside, and check against light.
Blocked mesh
Use hot water with 10% lemon juice, then brush and rinse.
Dishwasher
Exclude base and food pusher; filter top rack; hand washing preserves life.
Motor base
Damp-cloth wipe only—never immerse, rinse, or spray.

What you will need

  • The Breville BJE530 instruction manual
  • The supplied filter-basket cleaning brush
  • Warm water and mild dish soap
  • A soft cloth or sponge
  • A soft bottle brush for the jug and chute
  • A basin large enough for the filter basket
  • Lemon juice for the manual's 10 percent solution when needed
  • A clean drying rack and towels

Step-by-step instructions

Step 1: Stop, unplug, and dismantle safely

Turn the dial off, wait for the filter basket to stop completely, unplug, and move the cord away from the sink. Remove the juice jug and pulp container, lower the locking arm, lift off the cover, and lift the juice-collector-and-filter assembly as the manual shows. Never touch the cutting teeth while they are moving.

Step 2: Separate the filter basket without grabbing blades

Place the collector assembly over a sink or bench and carefully lift the filter basket by its rim. Its base has small sharp blades. Do not press fingers into the mesh or strike the basket to release pulp. Inspect it for cracks, deformation, or damaged mesh before washing.

Step 3: Rinse pulp immediately

Breville recommends rinsing all removable parts except the motor base promptly after use. Use warm running water to move pulp away from the cover, chute, collector, jug, lid, and pulp container. Keep the food pusher separate and hand-wash it. Dried fibers are harder to remove and can block filter holes.

Step 4: Wash non-electrical removable parts

Use warm soapy water with a soft cloth, sponge, or bottle brush. Clean chute corners, the collector spout, jug-lid channels, and pulp-container rim without abrasive pads. Rinse until surfaces no longer feel slippery. Strongly colored produce is less likely to stain when these parts are cleaned immediately.

Step 5: Soak the filter basket for ten minutes

Place the basket in hot soapy water for about ten minutes as Breville directs. Longer soaking in dried pulp can cement fibers rather than helping. Keep the basket alone so its blade plate does not scratch plastic and so another utensil cannot bend the precision mesh.

Step 6: Brush the basket inside and outside

Use the supplied brush in circular motions on the basket's inside, including around the blades, then brush the outside mesh. Hold it up to light: open holes should be visible evenly around the surface. Work away from sharp teeth. Do not use a wire brush, skewer, abrasive powder, bleach, or a damaged basket.

Step 7: Clear persistent blocked mesh

If holes remain blocked, Breville specifies soaking the basket in hot water with 10 percent lemon juice, then brushing again. Measure the dilution rather than pouring undiluted acid onto parts. Rinse thoroughly afterward. Replace a basket that stays clogged, becomes warped, or has torn mesh.

Step 8: Use the dishwasher option selectively

The manual says removable parts other than the food pusher may be dishwasher-safe, with the filter basket on the top rack, but it also warns that regular dishwasher use can shorten their life. Hand washing is the conservative routine. Never put the motor base or food pusher in the dishwasher.

Step 9: Wipe the motor base only

Use a damp soft cloth around the drive coupling, controls, and housing, then dry. Do not immerse the base, rinse it under a faucet, spray cleaner into vents, or let juice run beneath it. Sticky liquid near the motor, damaged cord, or unusual sound requires inspection rather than deeper wet cleaning.

Step 10: Dry, inspect, and reassemble

Air-dry every part fully, especially mesh, rim channels, and jug seals. Refit the basket into the collector, install the cover and pulp bin, and raise the locking arm only when pieces sit flat. Spin nothing by hand near the blades. Store assembled loosely or with airflow so hidden moisture cannot create odor.

Specific cleaning questions

Open a question for a concise answer about stains, odors, safety, frequency, and troubleshooting.

Is the Breville Juice Fountain Cold Plus dishwasher-safe?
Most removable BJE530 parts are dishwasher-safe according to the manual, but not the food pusher or motor base; put the filter basket on the top rack. Regular dishwashing may shorten part life.
How do I clean the BJE530 filter basket?
Soak it in hot soapy water for about ten minutes, then use the supplied brush in circles on the inside around the blades and across the outside mesh.
How do I unclog the Breville juicer mesh?
Hold the cleaned basket to light. If holes remain blocked, use Breville's hot-water solution with 10 percent lemon juice, then brush and rinse thoroughly.
Can I use bleach on the Juice Fountain filter?
No. Breville warns against bleach and harsh or abrasive cleaners. Use warm soapy water, the supplied brush, and the documented lemon solution for persistent blockage.
How do I remove beet or carrot stains from juicer parts?
Rinse and wash immediately after use. For remaining compatible-plastic discoloration, use the manual's 10 percent lemon-water approach, test briefly, and rinse rather than scrubbing abrasively.
Can the Breville motor base be washed?
No. Unplug it, wipe with a damp soft cloth, and dry. Never immerse the base, rinse it under a faucet, or spray liquid into vents or controls.
Why is my juicer still producing wet pulp after cleaning?
The mesh may still be blocked, the basket may be damaged or misseated, or produce may be fed too quickly. Inspect the dry basket against light and reassemble exactly.
When should I replace the Breville filter basket?
Replace it if the mesh is torn, deformed, persistently blocked, or the blade plate is damaged. Do not operate a compromised high-speed basket.